Featured Post

High CMRR Instrumentation Amplifier (Schematic and Layout) design for biomedical applications

on
Instrumentation amplifiers are intended to be used whenever acquisition of a useful signal is difficult. IA’s must have extremely high input impedances because source impedances may be high and/or unbalanced. bias and offset currents are low and relatively stable so that the source impedance need not be constant. Balanced differential inputs are provided so that the signal source may be referenced to any reasonable level independent of the IA output load reference. Common mode rejection, a measure of input balance, is very high so that noise pickup and ground drops, characteristic of remote sensor applications, are minimized.Care is taken to provide high, well characterized stability of critical parameters under varying conditions, such as changing temperatures and supply voltages. Finally, all components that are critical to the performance of the IA are internal to the device. The precision of an IA is provided at the expense of flexibility. By committing to the one specific task of
2

Simple Self Oscillating Switching Converter Circuit Diagram

on
This is a Simple Self Oscillating Switching Converter Circuit Diagram. Regulation is provided by taking the rectified output of the sense winding and applying it as a bias to the base of Q2 via zener Dl. The collector of Q2 then removes drive from the gate of Ql. 

Therefore, if the . output voltage should increase, Q2 removes the drive to Ql earlier, shortening the on time, and the output voltage will remain the same. De outputs are obtained by merely rectifying and filtering secondary windings, as done by D5 and C4.

Self Oscillating Switching Converter Circuit Diagram

Simple Self Oscillating Switching Converter Circuit Diagram

Comments

Post a Comment