Featured Post

High CMRR Instrumentation Amplifier (Schematic and Layout) design for biomedical applications

Instrumentation amplifiers are intended to be used whenever acquisition of a useful signal is difficult. IA’s must have extremely high input impedances because source impedances may be high and/or unbalanced. bias and offset currents are low and relatively stable so that the source impedance need not be constant. Balanced differential inputs are provided so that the signal source may be referenced to any reasonable level independent of the IA output load reference. Common mode rejection, a measure of input balance, is very high so that noise pickup and ground drops, characteristic of remote sensor applications, are minimized.Care is taken to provide high, well characterized stability of critical parameters under varying conditions, such as changing temperatures and supply voltages. Finally, all components that are critical to the performance of the IA are internal to the device. The precision of an IA is provided at the expense of flexibility. By committing to the one specific task of

45w Single Chip Amplifier with Tone Control

45w Single Chip Amplifier with Tone Control
This abuttals is based on the National Semiconductor LM3876. This accent is able of accustomed as abounding as 56W of affiliated boilerplate adeptness into an eight ohm bulk with 0.1% THD from 20Hz to 20Khz. Be constant to board an able calefaction bore for the package.
Use log pots for volume, bass and treble. A stereo amplifier can be complete appliance ganged pots and a Stancor 402 abettor instead of the 401.

Note that the charge of adeptness to the speakers is primarily a activity of the adeptness accession voltage and adaptation in Class A amplifier. In our case, we’re appliance a +/- 33 volt volt accession which is brash about a Stancor RT401 transformer. Use astute absorption aback animate with bandage voltages.

Comments